Journal of Mechatronics, Electrical Power, and Vehicular Technology

Kuspriyanto, Suhendar, D Saefudin, VA Azis. Hardware Simulation of Automatic Braking System Based On Fuzzy Logic Control 

Basjaruddin, N.C.

2016

Journal of Mechatronics. Electrical Power. and Vehicular Technology

7(1), pp. 1-6

2

Optimal selection of LQR parameter using AIS for LFC in a multi-area power system

Abdillah, M., Setiadi, H., Reihara, A.B., (...), Farid, I.W., Soeprijanto, A.

2016

Journal of Mechatronics, Electrical Power, and Vehicular Technology

7, pp. 93-104

7

Development of a fixed wing unmanned aerial vehicle (UAV) for disaster area monitoring and mapping 

Nugroho, G., Taha, Z., Nugraha, T.S., Hadsanggeni, H.

2015

Journal of Mechatronics, Electrical Power, and Vehicular Technology

6(2), pp. 83-88

2

Geometry Analysis and Effect of Turbulence Model on the Radial Rotor Turbo-Expander Design for Small Organic Rankine Cycle System 

Arifin, M., Pasec, A.D., Eddy, Z.

2015

Journal of Mechatronics, Electrical Power, and Vehicular Technology

6(1), pp. 39-48

1

Prediction model of battery state of charge and control parameter optimization for electric vehicle 

Wahono, B., Ismail, K., Ogai, H.

2015

Journal of Mechatronics, Electrical Power, and Vehicular Technology

6(1), pp. 31-38

1

Nonlinear dynamic modeling of a fixed-wing unmanned aerial vehicle: A case study of Wulung 

Triputra, F.R., Trilaksono, B.R., Adiono, T., Sasongko, R.A., Dahsyat, M.

2015

Journal of Mechatronics, Electrical Power, and Vehicular Technology

6(1), pp. 19-30

5

Comparison of unmodulated current control characteristics of permanent magnet synchronous motor 

Muqorobin, A., Irasari, P., Taufik

2014

Mechatronics, Electrical Power, and Vehicular Technology, MEV Journal

5(2), pp. 115-122

1

Learning efficiency of consciousness system for robot using artificial neural network 

Shoubaky, O., Sharari, T.M.

2014

Journal of Mechatronics, Electrical Power, and Vehicular Technology

5(2), pp. 91-98

1

Design of vibration absorber using spring and rubber for armored vehicle 5.56 mm caliber rifle 

Nugraha, A.S., Budiwantoro, B., Rijanto, E.

2014

Journal of Mechatronics, Electrical Power, and Vehicular Technology

5(2), pp. 75-82

1

Proportional derivative active force control for x configuration quadcopter 

Niam, T., Endra, P., Gede Puja, A.I.

2014

Journal of Mechatronics, Electrical Power, and Vehicular Technology

5(2), pp. 67-74

4

A trajectory generation method based on edge detection for auto sealant cartesian robot 

Maarif, E.S., Pitowarno, E., Widodo, R.T.

2014

Journal of Mechatronics, Electrical Power, and Vehicular Technology

5(1), pp. 27-36

2

MPPT based on fuzzy logic controller (FLC) for photovoltaic (PV) system in solar car 

Aji, S., Ajiatmo, D., Robandi, I., Suryoatmojo, H.

2013

Journal of Mechatronics, Electrical Power, and Vehicular Technology

4(2), pp. 127-134

3

Object recognition system in remote controlled weapon station using SIFT and SURF methods 

Mirdanies, M., Prihatmanto, A.S., Rijanto, E.

2013

Mechatronics, Electrical Power, and Vehicular Technology

4(2), pp. 99-108

3

Performance of EEG-P300 classification using backpropagation neural networks 

Turnip, A., Soetraprawata, D.

2013

Journal of Mechatronics, Electrical Power and Vehicular Technology

4(2), pp. 81-88

9

The performance of EEGP300 classification using backpropagation neural networks 

Turnip, A., Soetraprawata, D.

2013

Journal of Mechatronics, Electrical Power, and Vehicular Technology

4(2), pp. 81-88

1

Design and development of control system for nanofibre electrospinning

Kurniawan, D., Adhi, P.

2013

Journal of Mechatronics, Electrical Power and Vehicular Technology

4(2), pp 65-74

1

Maximum Power Point Tracking of Photovoltaic System for Traffic Light Application 

Muhida, R., Legowo, H.A., Irawan, R., Astuti, W.

2013

Mechatronics, Electrical Power, and Vehicular Technology

4(1), pp. 57-64

2

Quality improvement evaluation of the modified diesel-electric train (KRDE)

Taufik, H., Alam, H.S.

2013

Mechatronics, Electrical Power, and Vehicular Technology

4(1), pp. 51-56

1

IMU application in measurement of vehicle position and orientation for controlling a pan tilt mechanism 

Saputra, H.M., Abidin, Z., Rijanto, E.

2013

Journal of Mechatronics, Electrical Power, and Vehicular Technology

4(1), pp. 41-50

2

Autoregressive integrated adaptive neural networks classifier for EEG-P300 classification 

Soetraprawata, D., Turnip, A.

2013

Journal of Mechatronics, Electrical Power, and Vehicular Technology

4(1), pp. 1-8

1

Design of a DC-AC link converter for 500W residential wind generator

Muhida, R., Zaidi, A.F.A., Tamsir, A., Irawan, R.

2012

Mechatronics, Electrical Power, and Vehicular Technology (MEV)

3(2), pp. 95-102

1

The effect of ethanol-diesel blends on the performance of a direct injection diesel engine

Nur, A.

2012

Mechatronics, Electrical Power, and Vehicular Technology

3, pp. 49-56

1

Analytical and numerical deflection study on the structure of 10 kw low speed permanent magnet generator

Syaeful Alam, H., Irasari, P., Dewi, D.K.

2012

Journal of Mechatronics, Electrical Power, and Vehicular Technology

3(2), pp. 87-94

1

Isolation and Characterization of Lignin from Alkaline Pretreatment Black Liquor of Oil Palm Empty Fruit Bunch and Sugarcane Bagasse

Lubis, M.A.R., Dewi, A.R., Risantoa, L., Zaini, L.H., Hermiatia, E.

2012

Mechatronics, Electrical Power, and Vehicular Technology

2, pp. 1-5

1

The effect of the addition of active digester effluent for start-up accelerator in anaerobic digestion of soybean curd industry waste water (basic research for biogas power generation) 

Wresta, A., Budhijanto, W.

2012

Journal of Mechatronics, Electrical Power & Vehicular Technology

3(2), pp. 81-86

2

A review of atomic layer deposition for nanoscale devices 

Riyanto, E., Rijanto, E., Prawara, B.

2012

Journal of Mechatronics, Electrical Power, and Vehicular Technology

3(2), pp. 65-72

1

Modeling and identification of oxygen excess ratio of self-humidified PEM fuel cell system 

Leksono, E., Pradipta, J., Tamba, T.A.

2012

Mechatronics, Electrical Power, and Vehicular Technology

3(1), pp. 39-48

3

Analysis of inverse angle method for controlling two degree of freedom manipulator 

Saputra, H.M., Abidin, Z., Rijanto, E.

2012

Journal of Mechatronics, Electrical Power, and Vehicular Technology

3(1), pp. 9-16

1

The Use of Open Source Software for Open Architecture System on CNC Milling Machine 

Subagio, D.G., Atmaja, T.D.

2011

Journal of Mechatronics, Electrical Power and Vehicular Technology

2(2), pp. 105-112

1

Perancangan dan Pengujian Awal Kendali Motor DC Brushless untuk Independent 4-Wheel Drive Platform Robot Rev-11 

Saputra, R.P.

2011

Journal of Mechatronics, Electrical Power, and Vehicular Technology

2(2), pp. 85-94

1

Machine vision implementation in rapid PCB prototyping 

Murijanto, Y.S., Rusyadi, R., Sinaga, M.

2011

Journal of Mechatronics, Electrical Power, and Vehicular Technology

2(2), pp. 79-84

1

Study of biogas for power generation at pesantrensaungbalong al-barokah, majalengka, west Java 

Arifin, M., Saepudin, A., Santosa, A.

2011

Journal of Mechatronics, Electrical Power, and Vehicular Technology

2(2), pp. 73-78

3

Parabolic trough solar collector initial trials 

Pikra, G.

2011

Journal of Mechatronics, Electrical Power and Vehicular Technology (JMEV)

2(1), pp. 57-64

1

Desain dan Implementasi Sistem Kendali CNC Router Menggunakan PC untuk Flame Cutting Machine 

Saputra, R.P., Muqorrobin, A., Santoso, A., Purwanto, T.P.

2011

Journal of Mechatronics, Electrical Power and Vehicular Technology

2(1), pp. 41-50

3

Rancang bangun sistem kontrol mekanisme pelacakan matahari beserta fasilitas telekontrol hemat energi 

Mirdanies, M., Ardiansyah, R.A., Saputra, H.M., (...), Rijanto, E., Santoso, A.

2011

Journal of Mechatronics, Electrical Power, Vehicular Technology

2,(1) pp. 31-40

1

Modification of Surface Roughness and Area of FeCrAl Substrate for Catalytic Converter using Ultrasonic Treatment

Putrasari, Y., Untoro, P., Hasan, S., Sebayang, D.

2010

Journal of Mechatronics, Electrical Power, and Vehicular Technology

1(2), pp. 53-60

3

Survey of potential of micro hydro power plant in kuta malaka regency of aceh besar province of nanggro aceh darusalam

Arief Subekti, R.

2010

Journal of Mechatronics, Electrical Power, and Vehicular Technology

1(1), pp. 5-12

1

Fuel subsidy and air pollution reduction by policy program of conversion fuel CNG for vehicles in west java province. Journal of Mechatronics 

Susanti, V., Hartanto, A., Ridwan, A.S., (...), Estiko, R., Hapid, A.

2010

Electrical Power, and Vehicular Technology

1(2), pp. 43-52

1

Ocean current energy conversion system in wallacea region using variable speed control approach 

Nugraha, A.S., Estiko, R.

2010

Journal of Mechatronics Electrical Power and Vehicular Technology

1(1), pp. 27-34

1