Design of Vibration Absorber using Spring and Rubber for Armored Vehicle 5.56 mm Caliber Rifle
This paper presents a design of vibration absorber using spring and rubber for 5.56 mm caliber rifle armored vehicle. Such a rifle is used in a Remote-Controlled Weapon System (RCWS) or a turret where it is fixed using a two degree of freedom pan-tilt mechanism. A half car lumped mass dynamic model of armored vehicles was derived. Numerical simulation was conducted using fourth order Runge Kutta method. Various types of vibration absorbers using spring and rubber with different configurations are installed in the elevation element. Vibration effects on horizontal direction, vertical direction and angular deviation of the elevation element was investigated. Three modes of fire were applied i.e. single fire, semi-automatic fire and automatic fire. From simulation results, it was concluded that the parallel configuration of damping rubber type 3, which has stiffness of 980,356.04 (N/m2) and damping coefficient of 107.37 (N.s/m), and Carbon steel spring whose stiffness coefficient is 5.547 x 106 (N/m2) provides the best vibration absorption.
W. E. Dixon, D. M. Dawson, E. Zergeroglu Malithong, â€œAdaptive tracking control of a wheeled mobile robot via an uncalibrated camera system,â€? IEEE Transactions on Systems, Man, and Cybernetics,Vol. 31, pp.341-352, 2001. crossref
H. M. Saputra, Z. Abidin, E. Rijanto, â€œIMU Application in Measurement of vehicle position and orientation for controlling a pan tilt mechanism,â€? Journal of Mechatronics, Electrical Power, and Vehicular Technology,2013,Vol.4,No.1, pp.41-50. crossref
M. Mirdanies, A. S. Prihatmanto, E. Rijanto, â€œObject recognition system in remote controlled weapon station using SIFT and SURF methods,â€? Journal of Mechatronics, Electrical Power, and Vehicular Technology, 2013, Vol.4, No.2, pp.99-208. crossref
E. H. Choi, J. B. Ryoo, J. R. Cho, O. K. Lim, â€œOptimum suspension unit design for enhancing the mobility of wheeled armored vehicles,â€? Journal of Mechanical Science and Technology, Vol. 24, pp. 323-330, 2010. crossref
F. L. Neto, B. Santos, â€œA Procedure for the parametric identification of viscoelastic dampers accounting for preload,â€? J. of the Braz. Soc. of Mech. Sci. & Eng., Vol.XXXIV, pp. 213-218, 2011. crossref
A. Shirahatt, P. Prasad, P. Panzade, M. Kulkarni, â€œOptimal design of passenger car suspension for ride and road holding,â€? Journal of the Brazilian Society of Mechanical Science and Engineering, Vol.XXX, pp. 66-76, 2008. crossref
M. Bayat, I. Pakar, â€œOn the approximate analytical solution to non-linear oscillation systems,â€? Journal of Shock and Vibration, Vol. 20, pp. 43-52, 2013. crossref
Metrics powered by PLOS ALM
- There are currently no refbacks.